- Maximum discharge diameter: 2"
- Maximum flow: 27 m³/h
- Maximum pressure: 400m
- Maximum liquid temperature: 30°C
- Type of fluid handled: Clean water
-
Stainless steel submersible pumps with noryl rotor for pumping drinking water in installations such as tubular and deep wells. They generate low noise levels and have an integrated check valve that ensures minimal pressure loss. -
Centrifugal pumps with segmented body and single suction, with one or multiple stages for vertical or horizontal installation. They have mixed hydraulic systems with reduced impeller diameters, driven by submersible motors. Ideal for general supply systems, among other applications. • Maximum flow: 1,010 m³/h • Maximum pressure: 460 m • Maximum operating temperature: 50°C • Maximum rotation speed: 3500 rpm • Type of fluid handled: Clean water
-
-
-
Fully automatic pressure equipment with 2 or 3 (MVP) / 4 (SVP) vertical high pressure pumps in two variable speed models. The MVP and SVP variable speed models have continuous speed regulation on each pump through the frequency converter in the pump for asynchronous motors (MVP) or the PumpDrive speed regulation system and the KSB SuPremE motor (SVP), for fully electronic control of the required supply pressure. Equipped with central fuse box. -
Fully automatic pressure equipment with 2 or 3 (MVP) / 4 (SVP) vertical high pressure pumps in two variable speed models. The MVP and SVP variable speed models have continuous speed regulation on each pump through the frequency converter in the pump for asynchronous motors (MVP) or the PumpDrive speed regulation system and the KSB SuPremE motor (SVP), for fully electronic control of the required supply pressure. Equipped with central fuse box.
-
The device consists of two pressure sensors and a display that records the pump load and indicates any potential for optimising the pump's efficiency and availability. The device consists of two pressure sensors and a display panel. PumpMeter is fully equipped at the factory and is configured according to the respective pump. It is connected via an M12 connector and is ready for immediate use. -
CL 95 Non-toxic, fully rewindable, oil-bath submersible motors, NEMA connection. Axial load: 3000 to 6500 N. Designed, manufactured and tested in SAER workshops, the CL series motors ensure high reliability. Made in Italy guarantees high quality standards. For temperatures up to 35°C. CLE 95 Non-toxic, fully rewindable, oil-bath submersible motors. The “E” version has been designed to offer a solution with a better quality-price ratio than the CL series: the only difference is a reduced axial load (1500 N in the CLE version compared to 3000 N for the CL series), but it is made from the same materials. Tested and extremely reliable motors as standard, which can be coupled to any submersible pump, not just SAER, thanks to the NEMA connection. For temperatures up to 25°C.
-
-
Single-stage horizontal pumps, horizontal single suction and vertical discharge. Design back-pull-back, allows maintenance and repair services to be carried out from the rear without affecting the alignment or fixing of the pipes. Dimensionally constructed according to DIN 24256 /ISO 2858 standard, and mechanically according to ANSI B 73.1 standard.
-
Horizontal centrifugal pumps with radially split cast casing with coupling in back-pull out design. Available with different types of impellers: unassailable, open and multi-channel. Recommended for pumping wastewater, chemical effluents, muddy and dense liquids, viscous liquids and liquids with suspended solids.
-
Horizontal pump with radially split spiral casing in “back pull-out” design, with radial impeller, single-suction, single-stage, in accordance with DIN EN ISO 5199, measurements in accordance with DIN EN ISO 2858 complement the nominal diameters of DN25 and ≥DN200 , in a wide variety of materials and seals, also available with a wet shaft design and conical closing chamber. Available in ATEX version.
