-
Suitable for domestic installations, water supply, small gardening, increasing pressure in water supply networks. They ensure minimal hydraulic loss and, being designed and manufactured in Italy, are a guarantee of high quality. • Maximum flow rate: 8 m³/h • Maximum pressure: 59 m • Maximum power: 3 hp • Maximum operating temperature: 70°C • Maximum rotation speed: 3450 rpm • Type of fluid handled: Clean water -
Single-stage or multistage submersible electric pump for deep wells, for vertical or horizontal installation, built entirely in stainless steel, for well diameters of 150 mm (6”) and larger. Technical data • Maximum flow rate: 80 m³/h • Maximum pressure: 420 m • Maximum operating temperature: 50°C • Maximum rotation speed: 3500 rpm • Type of fluid handled: Clean water
-
-
-
Submersible, vertical centrifugal pump, polypropylene monobloc with noryl impeller, IP 68, single-stage, with level control in single-phase version, immersion depth 2 m. includes 10 m of cable. Applications: Automatic drainage of buckets, wells, tanks and warehouses at risk of flooding, reduction of surface water levels, drainage, drainage of underground passages, extraction of water from rivers and reservoirs.
-
-
Horizontal pump with radially split spiral casing in “back pull-out” design, with radial impeller, single-suction, single-stage, in accordance with DIN EN ISO 5199, measurements in accordance with DIN EN ISO 2858 complement the nominal diameters of DN25 and ≥DN200 , in a wide variety of materials and seals, also available with a wet shaft design and conical closing chamber. Available in ATEX version.
-
Horizontal centrifugal pumps with radially split cast casing with coupling in back-pull out design. Available with different types of impellers: unassailable, open and multi-channel. Recommended for pumping wastewater, chemical effluents, muddy and dense liquids, viscous liquids and liquids with suspended solids.
-
Single-stage horizontal pumps, horizontal single suction and vertical discharge. Design back-pull-back, allows maintenance and repair services to be carried out from the rear without affecting the alignment or fixing of the pipes. Dimensionally constructed according to DIN 24256 /ISO 2858 standard, and mechanically according to ANSI B 73.1 standard.
-
-
CL 95 Non-toxic, fully rewindable, oil-bath submersible motors, NEMA connection. Axial load: 3000 to 6500 N. Designed, manufactured and tested in SAER workshops, the CL series motors ensure high reliability. Made in Italy guarantees high quality standards. For temperatures up to 35°C. CLE 95 Non-toxic, fully rewindable, oil-bath submersible motors. The “E” version has been designed to offer a solution with a better quality-price ratio than the CL series: the only difference is a reduced axial load (1500 N in the CLE version compared to 3000 N for the CL series), but it is made from the same materials. Tested and extremely reliable motors as standard, which can be coupled to any submersible pump, not just SAER, thanks to the NEMA connection. For temperatures up to 25°C.
-
The device consists of two pressure sensors and a display that records the pump load and indicates any potential for optimising the pump's efficiency and availability. The device consists of two pressure sensors and a display panel. PumpMeter is fully equipped at the factory and is configured according to the respective pump. It is connected via an M12 connector and is ready for immediate use.
We are a hydraulic projects company founded in the Dominican Republic in 1988, dedicated to the sale, installation and maintenance of hydraulic equipment.
Hidrosistemas Dominicana, SRL | Website designed by chezaad.com